Which connectors did you use ?

Philippe Beuthe

Member
User
Sep 3, 2021
6
0
1
Belgium
Hello to the iFactory team,

I am busy studying an assembly where control panel, monitor, coil and end-of-filament control are all on the same side.
This involves reviewing the length of the cables.
I see you use AWG 24 cable tablecloths for control cables, and AWG 14 for power supplies.

Could you find out the connector references for:

- the orange connector (indicated "XT60") motherboard / heatbed,
- the 1x2 ckt connector of the motherboard / heatbed temperature control (Molex? But what type?),
- white 1x6 ckt connectors of axle motor controls.

Thank you in advance because it would make me save a lot of time!
 

harpo99999

Member
User
May 25, 2021
11
1
3
a simple google for xt60 connector indicates that it is mostly used in RC craft for connections to the main power storage & charging
the 3d printer control board connectors are usually jrt in 2 pin, 3 pin or 4 pin, and the connecter on the stepper motor is a jrt 6 pin(these are from other printers, but have been in use for several years now, so should be the same as used in the ifactory 1( I am still waiting on the 1 pro that i ordered in the ks)
 

Philippe Beuthe

Member
User
Sep 3, 2021
6
0
1
Belgium
... and you are absolutely right !

I have no experience in RC and my research on the XT60 gave me no results ... except today !
It's annoying, but it must have been a day with bad karma ...
Thank you very much for your info.

It seems to me that the connectors look like the JST XH 2.54 mm.

For the 1 pro, they wrote to me that "The Kickstarter printers are planned to get sent out by the end of this year. So it can be October until December, depending on how many printers will be sold and other varieties."