Could use some more help

goregut

Active member
User
May 5, 2021
30
9
8
Spring Hill, KS USA
@Julian or anyone. I'm having a rough time with this printer. I can't seem to get consistent prints. Usually it's the front (beginning of the print) curls up a bit. Even when there's good stick to the bed. Now I have layer shifting. It's about to the point where I want to just start over with instructions, but they were such a nightmare before. Any tips on the layer shifts and the curling?

IMG_0494.jpg
IMG_0495.jpg
IMG_0496.jpg
 

Julian

Well-known member
Staff member
iFactory3D Team
Mar 24, 2021
63
5
8
Germany
ifactory3d.com
Turns out the shifting was (surprise surprise) caused by a loose belt. So Now my concerns are the curling.
Hey,

the curling sometimes does appear when you print right before the edge of the heat bed AND/OR if the nozzle is to near to the belt. Could you please show me a side view of your belt where i can see the position of the nozzle over the heatbed?